Hi, Please share your program with error screen shot or video. I will check and update you.

Thank You.

Hi , can you please share your program ? I will check and update you.

E-Mail: kunal17home@yahoo.co.in

Thank You

It was difficult without backup… At least you have HMI backup then you can redirect the date using HMI port..

1. Connect the Devices: Ensure that the load cell, scanner, and printer are properly connected to the FX5U PLC. The load cell will typically connect to an analog input module, while the scanner and printer may connect via digital inputs/outputs or a communication module.
2. Read Analog Input Data: For the load cell, configure an analog input channel on the FX5U PLC using the appropriate analog input module. The FX5U PLC supports various types of analog input modules, so refer to the specific module’s manual for wiring and configuration instructions. Once configured, you can read the analog input data from the corresponding special register in the PLC. The special register address will depend on the configuration of your analog input module.
3. Process Data: After reading the analog input data, you may need to process it according to your application requirements. This could involve scaling, filtering, or performing other calculations to convert raw sensor data into meaningful measurements (e.g., weight).
4. Control the Printer: To print data from the PLC, you’ll need to interface with the printer. Depending on the type of printer you’re using (e.g., thermal, dot matrix), you may need to send commands or data in a specific format. This typically involves using communication protocols such as RS-232, RS-485, Ethernet, or USB, depending on how the printer connects to the PLC. Refer to the printer’s manual for communication protocol details and command format.
5. Send Data to the Printer: Once you have the data you want to print, format it according to the requirements of your printer and send it using the appropriate communication method. This could involve sending ASCII text, binary data, or printer-specific commands depending on the printer model and protocol.

1. Understand the Input Range: First, you need to know the input range of the analog output card. For the IC693ALG392, check the datasheet or user manual to determine the input range supported by the card. This range typically specifies the minimum and maximum values that can be output by the card
2. Determine Desired Output Range: Decide on the desired output range that you want to achieve. This could be based on the requirements of your application or the range supported by the receiving device.

Copying a program from a Siemens S7-1516 PLC without using any programming software is not possible. Siemens PLCs require specialized programming software such as TIA Portal or Step 7 for programming, monitoring, and transferring programs to and from the PLC.

Using the programming software provided by Mitsubishi (like GX Works3), access the communication settings for your PLC. Within these settings, you should find options to configure the link refresh rate. Adjust this rate according to your application requirements.

Nope.. Do not have it..Sorry

May be it was not compatible or firmware issue ..

Yes you can .. Just you have to create logic for that..